Ntel 4G LTE APN settings and configuration guide
today i am going to be showing you how to Configure your Ntel configuration settigs and APN so you can Access the Internet with your Ntel Sim..
Ntel 4G LTE APN Requirements
1. Make sure that your cell phone is Flexible Division Duplex (FDD) with support for LTE 3 (1800MHz) and 8 (900MHz) spectrum bands. You can easily find this information on the product packaging or documentation which usually comes with it.
2. You will need to enable 4G services in your device and to do this,
HOW TO ENABLE 4G LTE ON ANDROID
simply go to the Mobile Networks on your phone and select Select 4G (recommended) or LTE Only as your preferred network mode.
3. Then, go to Access Point Names (APN) settings and create a new APN and name it “Ntel 4G” or any name of your choice which you can use to identify it. Note that this settings might vary depending on the phone brand you are using. After locating the phone APN, then use the following "configuration" below
Ntel 4G APN internet settings (Option One)
APN: ntel
username: ntel
password: ntel
Then leave every other field in the APN Settings and save it and activate as your default or active APN. After this, try browsing and it should connect but if after applying the settings above and you still find it unable to browse, then use the second option below.
Ntel 4G internet settings ( Option Two)
APN: ntel
username: blank
password: blank
after trying this you should be able to access the internet with Either of the Above Settings..
Always Remember To Use The Share Buttons,Sharing Is Caring
Ntel 4G LTE APN settings and configuration guide
Reviewed by TricksBar
on
June 09, 2016
Rating:
Reviewed by TricksBar
on
June 09, 2016
Rating:
Post a Comment